Mandalorian Mercs Costume Club

Mandalorian Armor => Helmets => Topic started by: Jester0153 on May 09, 2021, 07:27 PM

Title: My Bucket WIP
Post by: Jester0153 on May 09, 2021, 07:27 PM
Hey guys. This is my first project for my own Mando and I'm trying to figure out if my sizing is correct. I tried a smaller version and it wouldn't fit at all, and with this one (pics below, was a 3D print that has been glued, sanded, and filled) it fits my head, has room for pads and electronics, but I keep feeling like its way to big for my head and body. Should I scrap and start over or is there another trick? Any help would be appreciated.
(https://i.imgur.com/1scRrPj.jpg)
(https://i.imgur.com/FNlRDbD.jpg)
(https://i.imgur.com/FYPBJwV.jpg)
(https://i.imgur.com/OPimwv6.jpg)
(https://i.imgur.com/fKuU6me.jpg)
(https://i.imgur.com/Jn5nJd6.jpg)
(https://i.imgur.com/Qbibkef.jpg)
Title: Re: My Bucket WIP
Post by: Tramp Graphics on May 09, 2021, 09:25 PM
Looks good to me.  :8):
Title: Re: My Bucket WIP
Post by: Jester0153 on May 09, 2021, 09:31 PM
I'm thinking it's fine, but then I start staring at it and then it looks to big, then back to fitting right. I want to make sure it's sized properly before I start painting so I'm not wasting paint.
Title: Re: My Bucket WIP
Post by: jett drexel on May 10, 2021, 02:32 AM
once you have your shoulder plates on it'll look considerably smaller.  ;)
Title: Re: My Bucket WIP
Post by: Tramp Graphics on May 10, 2021, 09:11 AM
This^

Once your armor is on, it will all come together. Trust us. Itís not too big.
Title: Re: My Bucket WIP
Post by: Jester0153 on May 10, 2021, 12:19 PM
Alright! I'm putting my faith in it. 'm going to buy my paint today. Follow up soon!