activation email

[Ritpak Ordo]

Alrighty. So I have a question. I have the mk171 and want to put it in this loop. "Amp-vchanger-mic." Now I've read an found out if I remove the r6 on the board which is the boards mic resistor. Now I havnt done that yet cause I need to acquire my female side 3.5 jack, but when I wire up a aux to the speaker ports, I get all the feedback or interference in the world.

But would I have to mount a female jack to the speakers instead? And run a male/male aux to amp, and the changer. While I run the mic from the mic jack?

Any notes or tips is greatly appreciated.