activation email

[Thrig Skor]

Hey all,
this will be my build thread for my Custom Merc "Thrig's"

Deathwatch style flight suit being made by 3one8 Outfitters.


Armour Design (will be sourced from Christhepropguy):



Cape & Kama made by Aria ( Slightly burnt by me)



Weapons:


Primative style Beskar sword


Other parts:

[Bryn Cin'Prudii]

Wonderful concept! You may find you want to ditch the butt plate cause it will be hard to sit down....

[Thrig Skor]

Wonderful concept! You may find you want to ditch the butt plate cause it will be hard to sit down....

Thank you, yea was a little unsure of it but the way I have it planned the cod/butt plate will be what supports the kama and holsters, I'm going to have the kama fold up over the piece and have a Velcro strip running along the inside ajd the holsters belt with sit just above the top of the cod/butt piece

[Thrig Skor]

Soft Parts all collected, just some weathering to do.

and just the armour remaining

[Slade Kel]

Definitely off to a good start. Word to the wise, though, there are 3d print lines visible on the Westars, and alllllll print lines have to be completely gone for approval. So, body filler (or, better yet, XTC 3d resin), sand, repeat ad nauseam until the print lines are gone or your hands fall off . That goes for any and all 3d printed parts, so if your armor is going to be printed too, I'd suggest picking up a buttload of bondo or XTC and about forty thousand sheets of sandpaper .