Helmet
The helmet is painted chrome.
The helmet has a raised comb running along the centre of the dome, which is approx. 4cm/1,5 inches wide. This comb ends just above the keyslot box in the rear. The centre part of the comb is flat, with sloping sides.
The helmet has a double brow above the visor. This brow does not extend past the earcaps.
Both earcaps are mirrored copies of eachother and consist out of two sections. Both sections are painted chrome, with a dark colored band running across the side of the top part. The center raised part of the earcaps (both top and bottom part) are a lighter shade of chrome.
The back of the helmet has a rectangular box with 6 louvered keyslots. The louvres are a lighter shade of chrome.
The paint chipping and weathering on the helmet must be painted to match visual references as closely as possible both in color and in weathering pattern.
Helmet must match visual references.
Flight Suit
Must be a cotton or cotton blend one or two-piece garment colored medium gray with a purplish hue, and must fit snugly to the wearer. If a two-piece suit is used it must appear as if one-piece.
Must have long sleeves with short sleeves on top of them, both made from the same material. Each short sleeve has a plain seam about an inch thick running on the bottom edge and along the front of the sleeve. Both the short and long sleeves have a white pattern stitched on them.
The flightsuit has no visible pockets.
The flightsuit has visible, white stitching.
The knees and inside legs of the flightsuit have reinforcing patches.
The flightsuit has light weathering across its entirety.
Flightsuit must match visual references.
Neck seal
Must be made of the same material and color as the flightsuit.
The neckseal has visible, white stitching.
The neckseal has light weathering.
Neckseal must match visual references.
Flak Vest
flak vest made of the same material and color as the flightsuit.
The flak vest has black leather or faux leather straps on top which run the entire length of the shoulders.
The flak vest has light weathering across its entirety.
Flak vest must match visual references.
Cummerbund
Light brown colored cummerbund made from cotton or cotton blend material that covers the area between the flak vest and belt.
The cummberbund has piping on both sides
Must feature a leather or leather like apron on the front with raised details
The apron has a rounded flap which extends past the belt.
The cummerbund has light weathering across its entirety.
Cummerbund must match visual references.
Boots
Chelsea style boots.
Most accurate shoes are Sketchers brand "Blaine Orsen" boots
Light brown roughout leather or leather like material
The boots have a stitched on grey leather patch on the inside and brown flap on the front.
The boots have moderate weathering with several discoloured patches.
Boots must match visual references.
Chest Armor
Consists of a solid chest plate with an integrated diamond.
The sides of the diamond slope towards the center part.
The ab plate must touch the chest plate.
The fangs of the chest plate overlap the ab plate
The plates are painted chrome.
All plates must be painted and weathered to match references both in color and weathering pattern.
May feature optional carbon scoring/weathering inflicted by sniper fire in episode 5 or E-web blaster explosion in episode 8.
All armor must attach securely to the vest.
Chest armor must match visual references.
Back Armor
The backplate is painted chrome
Must be painted and weathered to match references both in color and weathering pattern.
In addition to his backplate, the Mandalorian wears a black, woollen cape which connects to the chest plate and covers the area between the shoulder plates and neck.
The cape has a hole in it through which a loop runs that holds the pulse blaster in place.
back armor must match visual references.
Kidney armor
Trapezoid shaped plate which attaches to the bottom of the belt.
The kidney plate is painted chrome
Must be painted and weathered to match references both in color and weathering pattern.
Kidney armor must match visual references.
Shoulder Armor
both shoulder plates are mirrored copies of each other
Shoulder plates must have a raised middle section and edges.
Both shoulder plates are painted chrome
May only feature the mudhorn signet if the weathering inflicted in episode 8 is present on the costume.
Must be painted and weathered to match references both in color and weathering pattern.
shoulder armor must match visual references.
Left shin Armor
Brown leather or leather like armor which runs the entire circumference of the shin.
The top part has a double band with a small leather pouch on the outside.
The middle part of the shin armor has a rounded, orange armored plate with a flat front.
The bottom section of the shin is ribbed.
Must be painted and weathered to match references both in color and weathering pattern.
Shin armor must match visual references.
Right shin Armor
Shoretrooper style shin armor without plastic reinforcing straps
The color of the shin is dark brown with the top V-shaped part painted reddish brown.
The shin has 2 leather straps where the original reinforcing straps where located.
The upper leather strap has 6 loops with blaster charges.
The shin has a blue and metal distressed knife in it.
Must be painted and weathered to match references both in color and weathering pattern.
Shin armor must match visual references.
Left thigh plate
Must appear to be at least 3mm thick with a thick rim running along the edge.
The thigh is painted chrome with black and red parts.
Must feature a raised middle section:
Must be painted and weathered to match references both in color and weathering pattern.
Thigh armor must match visual references.
Right thigh plate
Must appear to be at least 3mm thick with a thick rim running along the edge.
The thigh is painted chrome.
Must feature a raised middle section
Must feature visible damage and welding marks
Must be painted and weathered to match references both in color and weathering pattern.
Thigh armor must match visual references.
Hip armor
Two armored plates are located on the side, below the belt.
Must appear to be at least 3mm thick with rounded edges.
The plates are painted chrome.
Must feature a canted ridge running from top to bottom.
Must be painted and weathered to match references both in color and weathering pattern.
Hip armor must match visual references.
Left Gauntlet
The gauntlet is painted chrome.
Clamshell style gauntlets without any visible closure method.
Must feature a silver colored keypad on the wrist with 4 rows of 5 round buttons, of which the 3 center buttons of each row are slightly larger.
Must feature a half recessed whistling birds wrist rocket on the raised section;
Must be painted and weathered to match references both in color and weathering pattern.
Gauntlet must match visual references.
Right Gauntlet
The gauntlet is painted chrome.
Clamshell style gauntlets without any visible closure method.
The raised section of the gauntlet features a heads up display in the rear.
The top right side of the gauntlet has a cylindrical silver flamethrower inside a square housing.
Must be painted and weathered to match references both in color and weathering pattern.
Gauntlet must match visual references.
Ammo Belt
The belt is made from brown leather or leather-like material.
The left side of the belt has 1 square pouch and 3 explosive charges in a metal holder.
Each charge has a red, rounded plastic eye in the middle.
The right side of the belt has 1 cylindrical pouch and 2 loops with blaster charges
The belt is closed with a flat, silver buckle which has 2 screws on the front.
The rear of the belt has an additional 4 loops for blaster charges, 2 on each side.
The rear of the belt has a square metallic plate to which the bandoleer connects. This plate also has a leather belt loop for the pulse blaster.
Must feature a brown leather holster for the sidearm.
Belt must match visual references.
Gloves
The gloves are leather or leather-like material
Black fingerless gloves with golden tan fingers.
The gloves have an off white armor plate with a blue triangle in the center.
Gloves must match visual references.
Bandoleer
The belt has an attached bandoleer, which slings across the left shoulder.
The bandoleer has 6 loops in the middle which contain 4 blaster charges. The bottom loop and second loop from the top is empty.
The bandoleer has a silver buckle on top, which connects to the sling of the pulse blaster
Bandoleer must match visual references.
Jetpack
Arena style jetpack
The jetpack is painted chrome
Must feature 2 ribbed squares on the center body.
Jetpack may only be worn if the damage inflicted in episode 8 is present.
Weapon
Amban phase-pulse blaster
The blaster is gun metal with silver accents and a wooden stock
The forked barrel and body of the rifle have heat discolorations
Must be painted and weathered to match references in color and weathering pattern.
Weapon must match visual references.
This weapon is optional for this costume, as it is only used in episode 3 & 4, and no longer appears in the rest of the season.
Sidearm
Based on a Bergmann 1896 pistol
Features a silver-black conical muzzle
Sidearm must match visual references.