Don't like ads? Help support the Mercs by becoming a Supporter or Auxiliary Member today!
Official Members also get to use the forum ad-free - so kit up and join us!

 My Bucket WIP

  • 5 Replies
  • 280 Views
My Bucket WIP
« on: May 09, 2021, 07:27 PM »
Hey guys. This is my first project for my own Mando and I'm trying to figure out if my sizing is correct. I tried a smaller version and it wouldn't fit at all, and with this one (pics below, was a 3D print that has been glued, sanded, and filled) it fits my head, has room for pads and electronics, but I keep feeling like its way to big for my head and body. Should I scrap and start over or is there another trick? Any help would be appreciated.







Logged

Tramp Graphics


    *
  • 223
  • Illustrator
Re: My Bucket WIP
« Reply #1 on: May 09, 2021, 09:25 PM »
Looks good to me.  :8):

Logged
Re: My Bucket WIP
« Reply #2 on: May 09, 2021, 09:31 PM »
I'm thinking it's fine, but then I start staring at it and then it looks to big, then back to fitting right. I want to make sure it's sized properly before I start painting so I'm not wasting paint.

Logged

jett drexel


    *
  • 2118
  • a long time ago in a living room far far away...
Re: My Bucket WIP
« Reply #3 on: May 10, 2021, 02:32 AM »
once you have your shoulder plates on it'll look considerably smaller.  ;)

Logged

Tramp Graphics


    *
  • 223
  • Illustrator
Re: My Bucket WIP
« Reply #4 on: May 10, 2021, 09:11 AM »
This^

Once your armor is on, it will all come together. Trust us. Itís not too big.

Logged
Re: My Bucket WIP
« Reply #5 on: May 10, 2021, 12:19 PM »
Alright! I'm putting my faith in it. 'm going to buy my paint today. Follow up soon!

Logged
 


Don't like ads? Help support the Mercs by becoming a Supporter or Auxiliary Member today!
Official Members also get to use the forum ad-free - so kit up and join us!




Powered by EzPortal
anything