Don't like ads? Help support the Mercs by becoming a Supporter or Auxiliary Member today!
Official Members also get to use the forum ad-free - so kit up and join us!

 Basic PVC Pipe Vambrace Tutorial

  • 46 Replies
  • 24186 Views

Kurz


    *
  • *
  • *
  • 580
Re: Basic PVC Pipe Vambrace Tutorial
« Reply #45 on: Jun 10, 2018, 05:15 PM »
So I am in the middle of cutting some 4" pvc and following this tutorial, but I think something went wrong. After cutting out the wedge, the halves don't line up at all. The piece I cut is too narrow now and cutting off that extra half-inch didn't help either. If someone could point out what exactly I should have done, that would be great.





I think your cuts were not symmetrical

Logged
OM #2524
Cabur Akaata (Protector Battalion) #133
Oribru Akaata (Emergency Battalion) #31
M.V.S. #89
L.O.B. #66

Darth_Vemon


    *
  • 525
  • Crush your enemies, see them driven before you...
Re: Basic PVC Pipe Vambrace Tutorial
« Reply #46 on: Jun 10, 2018, 11:32 PM »
Unless you have a very funky shaped arm, you'll need to heat and reform the two pieces anyway.  At least, I did when following this tutorial.  I was able to get them to line up just fine after I did that.

Logged
K'dumi haran doslanir bat vheh ures aranov.

Benjin "Farlander" Kov'nyn

Check out my fanfic:
http://mandalorianmercs.org/forum/index.php?topic=130493.0

Cabur Akaata #49 M5SP #22 B.O.O.M. #21 Aluminati #46
 


Don't like ads? Help support the Mercs by becoming a Supporter or Auxiliary Member today!
Official Members also get to use the forum ad-free - so kit up and join us!




Powered by EzPortal
anything